Graybill's Tool and Die, Inc. - Precision Machining

	Graybill's Tool and Die, Inc.
Home Company Info History Shop Tour Facility List Directions Services Design Services Precision Machining Photos Machine Photos Electrical Panels Desk Top Equipment Pneumatics Contacts

Precision Machining

GTD is a precision machine shop. We specialize in single piece prototypes to short production runs. We have a hard earned, long standing reputation for quality and service that makes us very proud.

Listed below are some of our areas of expertise.

Precision Machining: +/- .0001" Tolerance
EDM: Wire & Plunge
Dies: Blank, Compound, Trim, Draw, Extrusion, Progressive, Prototype, Die Repair
Jigs, Fixtures, Gauges: - All Types
Molds: Extrusion, Plastic - Compression and Injection, Mold Repair, Prototypes
Welding: Oxy/Acetylene, A/C Stick, MIG/TIG
Stamping: Short Run - 26 Ton Max
CNC: 3D Milling
Low Volume: Move low volume production from your shop to ours and reduce your overhead and set/ups.

Shown below are some examples of precision machined parts.

Our Seiki milling center with automatic tool changer puts these holes in with ease. Over 200 holes in this plate are drilled and reamed press fit for pins.	The finished disk ready to be shipped

A highly polished surface finish was required on this part.	A surface finish of less than 2 micro inches was acheived.

These shafts had a diameter tolerance of .002 and a straighness tolerance of .003.

Some examples of Wire EDM parts.	This plate was 3d scultpure machined and is used to stamp a pattern into ceiling tile.

Front side of a prorotype heat sink.	Rear view of the prototype heat sink.

Views of a small prototype part.

Top of Page

For more information contact us at:
Graybill's Tool and Die, Inc.
147 W. High Street
Manheim, PA 17545
Voice: (717) 665-5546
Fax: (717) 665-3107

E-mail us at: info@graybills.com